This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
Text excerpt from page 19 (click to view)
3-1-5. Writing the EEP ROM
1. Start up the adjustment program VL500_Adj and click [MODE] and select [Adjust|Mode]. 2. Click [Initialize|EEPROM]. (It takes approximately 30 seconds for writing.) 3. Click [Start], and confirm that the camera shooting picture appears on the PC monitor. 4. Click [Stop]. 5. Click [Exit].
3-2. ADJUSTMENT
3-2-1. Setting
1. Start up the adjustment program VL500_Adj.exe and click [ADJ|Mode]. 2. Click [Start], and confirm that the camera shooting picture appears on the PC monitor. Confirm also that the POWER indicator LED (D800 on the IF-318 board) changes from green to orange.
3-2-2. Flange Back Adjustment (DFW-VL500 only)
Subject : Siemens Start chart 1. 2. 3. 4. 5. 6. Click [AE|Manual] And select [Manual]. Click Iris and set Iris to [Open]. Click [Zoom] and set the zoom to the Tele end. Drag the Zoom Offset slider and obtain the best focus. Click [Zoom] and set the zoom to the Wide end. Drag the Focus Offset slider and obtain the best focus.
