|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
Select an S-meter level. Point the arrow at ON using the UP/DOWN key. Select a level from 1 through 7 TF using the dial, and then press the ENT key. If you do not want to select any STF meter level, select OFF and then press the ENT key (the initial setting is OFF). Higher levels require stronger signals to stop scanning. The display will return to the SCAN mode. Point the arrow at END and then TF press the ENT key (Alternatively, you may press the F key, and then press TF the ENT key with shown on the display).
DOWN UP
3
Note:
If you exit the SCAN menu by pressing the canceled.
SKIP CLR
key, the changed setting is
3.1.17 Setting the scanning pause period
The scanning pause period for the TIMER option can be set.
1
F
MON I SRCH LAMP
Call up the SCAN menu. Press the F key, and then press SET the HELP key with shown on SCAN the display. SCAN MODE BUS Y T i me r The SCAN menu will appear. Point the arrow at +CONFIG using the dial or UP/DOWN
OWER P
PMS
SET
VFO AB
MR MW
SQL VOL
SET ATT MODE
1
HELP
STEP
2
3
M NAME
RF C
KL
MW
key, and then press the ENT key. The CONFIG menu will appear. Point the arrow at TF +SCAN SETUP and then press the ENT key.
TF
MIC
AUTO
A-B
S
2 3
Call up the BUSY TIMER screen. Point the arrow at +Busy Timer and then press the TF ENT key.
B u s y T i me r 5s
Set the scanning pause period. Set the scanning pause period using the dial or UP/DOWN key, and then press TF the ENT key (the initial setting is 5s). The display will return to the SCAN menu. Point the arrow at END and then TF press the ENT key (Alternatively, you may press the F key, and then press the shown on the display).
Note: If you exit the SCAN menu by pressing the canceled.
SKIP CLR
key, the changed setting is
44
|
|
|
> |
|
