|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
 ;
Very very good as usual very trustable site. Perfect!!!!!!
;
The Service Manual received was helpful. Good copy of original document.. I recomend all of my friends about this technical page.
;
Perfect, complete manual, exactly what I needed. Recommended to everyone.
;
Very usefull manual. From my point of view there are needs more clearables images.
3.4.2.
INITIAL SETTINGS:
When you replace the Main PCB, be sure to perform the initial settings after achieving the adjustment by ordering the following procedure in accordance with model suffix of the unit. 1. IMPORTANT NOTICE: Before proceeding Initial settings, be sure to read the following CAUTIONS.
2. PROCEDURES: � Precautions: Proceed the picture back up from the unit. (Refer to above "CAUTION 2") � Preparation. Set the Mode dial to "Normal Picture Mode" (Red camera mark). � Step 1. The temporary cancellation of initial setting: Set the [REC]/[PLAYBACK] selector switch to �[ REC ] (Red camera mark)�. While keep pressing [ DISPLAY ] and �[ UP ] of Cursor buttons� simultaneously, turn the Power on. � Step 2. The cancellation of initial setting: Set the [REC]/[PLAYBACK] selector switch to �[ PALYBACK ]�. Press [ DISPLAY ] and �[ UP ] of Cursor buttons� simultaneously, then turn the Power off. � Step 3. Turn the Power on: Set the [REC]/[PLAYBACK] selector switch to �[ REC ] (Red camera mark)�, and then turn the Power on. � Step 4. Display the INITIAL SETTING: While keep pressing [ MENU/SET ] and �[ RIGHT ] of Cursor buttons� simultaneously, turn the Power off.
10
|
|
|
> |
|
