|
|
|
Who's Online
There currently are 5523 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Zoom/Effects Edge/Book/Margin
I Procedure
B4·FLS
Place the Original(s)
Select ZOOM/ EFFECT Mode
Select Edge, Book or Margin
Number of Copies
Press START
Edge
# When the vertical and horizontal void areas are the same, adjust the void width by using the F·G buttons, then touch the OK button. # When the vertical and horizontal void areas are different, select vertical or horizontal edge. $ Adjust each void width by using the F·G buttons. % Touch the OK button.
Book
�
Initial setting (Factory setting): 5 mm
# Adjust void width by using the F·G buttons. $ Touch the OK button. � Initial setting (Factory setting): 20 mm
Margin
# Select the Margin area. $ Adjust void width by using the F·G buttons. The image is moved only by the void width which has been set.** % Touch the OK button. � Initial setting (Factory setting): 10 mm
NOTE
Initial setting (Factory setting) can be changed by the function mode. (See page 62) �� If a part of the copied image is missing when using the Margin mode, change the Margin Reduction setting to Yes. (See page 62) C To reset each menu mode, touch the CANCEL button on the touch panel.
�
41
Making Copies
1
2
3
45
|
|
|
> |
|
