|
|
|
Who's Online
There currently are 5595 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This service manual was determinant to enable to fix my Alpine Amplifier. I am pleased with my purchase. For a 5 star rating I would like to see a higher resolution scan of the printed circuit board lay-out because the gray scale grafics was dificult to see. Also some schematic diagrams were scanned at a slight angle. Never the less, it had all information I needed to troubleshoot and service my equipment.
 ;
Complete manual, the good quality of reproduction allows enlarged print-out of the schematic diagram in the size it probably had in the original print edition and which is necessary for practical use.
;
The service manual was complete and the components on the drawings very good visible.
;
downloaded next day , manual is very helpful , fast and easy
;
This Service Manual was exactly what I needed to repair my Philips TV. The purchase was convenient and I received the manual at the same day I paid for it.
6. GEOMETRY 6.1 VERTICAL CENTER
1) Set the TV to � NORMAL I�mode. 2) Enter the service mode. 3) Locate the cusor at � V.CENTER�then press � VOL +� or � VOL -�keys to adjust the center line with the mechanical center marks of the CRT.
6.2 VERTICAL SIZE
* The VERTICAL CENTER adjustment has to be done in advance. 1) Receive the Retma pattern. 2) Set the TV to � NORMAL I�mode. 3) Enter the service mode. 4) Locate the cursor at � V.SIZE�then press � VOL +� or � VOL -�keys to adjust the upper part of the picture.
6.3 HORIZONTAL CENTER
1) Apply a RETMA PATTERN signal. 2) Set the TV to � NORMAL I�mode. 3) Enter the service mode. 4) Locate the cursor at � H.CENTER�then press � VOL +� or � VOL -�keys to adjust the picture centering.
if EEPROM(I702) has been changed; - Option data has to be change and - all alignment function has to be readjusted * The initial state of adjustment are as follows; - V-Center, V-Size, H-Center, R, G, B, AFT = Center ( - AGC = * Service Remocon )
|
|
|
> |
|
