This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Text excerpt from page 14 (click to view)
Changing
(on some
a cycle
setting
models)
You can change a cycle setting anytime during any cycle. 1. Lii up the door latch to stop the cycle. 2. Turn the Cycle Control Knob cbckwise to the desired cycle. 3. Check the detergent dispensers. They must he filled properly for the new cycle. NOTE: Turning the Cycle Control Knob can cause the covered section of the detergent dispenser to open and release the detergent. Check the covered section if setting NORMAL WASH or POTS 8 PANS cycle. 4. Close the door firmly until it latches. The dishwasher starts the new cycle.
Adding
(on some
an item during
models)
a cycle
You can add an additional item to the dishwasher anytime before the Cycle Control Knob reaches LIGHT WASH. Items added after the Cycle Control Knob reaches LIGHT WASH will only he rii. 1. Lii up the door latch to stop the cycle. Wait for spraying action to stop before opening the door. 2. open the door and add the item. 3. Close the door, but do not latch it. Wait 30 seconds for the air in the dishwasher to warm up. Doing so reduces the amount of moisture in the vent when restarting a cycle. 4. Cbse the door firmly until it latches. The dishwasher resumes the cycle.