WHIRLPOOL DU5000XW0
Owner's Manual

Operating Continued

Instructions

Startingyourdishwasher
1. Select a drying option. (Use the Air Dry Option for Rinse 8 Hold Cycle.) 2. Turn Cycle Control Knob clockwise to point to a desired cycle. You will feel a definite stop at each cycle mark. The dishwasher will automatically start that cycle. NOTE: If the door is start and stop as the mark. This is normal washer If you prefer, door unlatched. latched, you will hear cycles knob passes each cycle and will not hurt the dishyou can set cycles with the

Toadda dishafterstarting
1. To be sure the added item is washed and rinsed, make sure the Cycle Control Knob has not passed LIGHT WASH. 2. Lift up on the door latch to unlatch door and stop the cycle. 3. Open the door and add the dish. 4. Close the door. Do not latch it. Wait 30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle. 5. Press door in to latch it. The dishwasher will start where it stopped.

Changing cyclesetting a
You can change a setting anytime during any cycle. 1. Lift up on the door latch to unlatch the door and stop the cycle. 2. Turn the Cycle Control Knob clockwise to the cycle you want. 3. Be sure the detergent dispensers are filled properly for the new cycle. When changing dial from LIGHT WASH to NORMAL WASH setting, detergent is released. Reload covered section of dispenser before starting Normal Wash Cycle. 4. Close and latch the door. The dishwasher will automatically start the new cycle.