The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Text excerpt from page 4 (click to view)
Operating Continued
Instructions
Startingyourdishwasher
1. Select a drying option. (Use the Air Dry Option for Rinse 8 Hold Cycle.) 2. Turn Cycle Control Knob clockwise to point to a desired cycle. You will feel a definite stop at each cycle mark. The dishwasher will automatically start that cycle. NOTE: If the door is start and stop as the mark. This is normal washer If you prefer, door unlatched. latched, you will hear cycles knob passes each cycle and will not hurt the dishyou can set cycles with the
Toadda dishafterstarting
1. To be sure the added item is washed and rinsed, make sure the Cycle Control Knob has not passed LIGHT WASH. 2. Lift up on the door latch to unlatch door and stop the cycle. 3. Open the door and add the dish. 4. Close the door. Do not latch it. Wait 30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle. 5. Press door in to latch it. The dishwasher will start where it stopped.
Changing cyclesetting a
You can change a setting anytime during any cycle. 1. Lift up on the door latch to unlatch the door and stop the cycle. 2. Turn the Cycle Control Knob clockwise to the cycle you want. 3. Be sure the detergent dispensers are filled properly for the new cycle. When changing dial from LIGHT WASH to NORMAL WASH setting, detergent is released. Reload covered section of dispenser before starting Normal Wash Cycle. 4. Close and latch the door. The dishwasher will automatically start the new cycle.
