Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
Text excerpt from page 71 (click to view)
5
6
7
8
Arrangement of the flexible cable for the pickup
: Conductive surface Note: Be sure to move the Pickup Assy-S to the innermost perimeter.
A
1 2 3
Fold the flexible cable inward at the position of the reference line. Attach the flexible cable of the pickup to the connector. Fold the flexible cable of the pickup with the backing inward.
7
Pass the flexible cable below the hook, and fold it back. Make sure that the cable does not have any slack
7
Reference line
2
3
1
Hook
B
Backing 97mm ± 2mm
Front Side
Bottom View
8 4
Pass the flexible cable through the hook not allowing any slack. Make sure there is no slack in the cable Reference line
Fold the flexible cable back at the hook. Make sure that the cable is loose Hook
C
8 4
Hook
D
5 6
Fold the flexible cable as indicated in the photo. Hook the part folded in Step 1 to the hook.
