Very fast service, best quality of the service manual and the schematics
Text excerpt from page 117 (click to view)
5
6
7
8
Check 5: Is the video circuit operated normally?
Reproduce DVD-REF-A1(GGV1018) Title 2 Chapters (White 100IRE). Monitor the output with the oscilloscope, by setting the COMPO signal to a GND reference. Set the Trigger mode to the TV trigger, and the Trigger line to line-150.
A
NO. 1
Verification location (sensing pin) COMPO
Rated value 1.0±0.02Vpp
Reference waveform Waveform 6
If the result is not satisfactory, check to see if there are any problems with resin flux cored solder, parts and components, in the vicinity of line-150 (the section marked 5 in the circuit diagram) and peripheral components
PEAK
COMPO signal
Rated value Color burst Pedestal BOTTOM Horizontal periodic signal
When the result is not satisfactory, adjust the noise level to 1.0 + 0.02 Vpp.
