|
|
|
Who's Online
There currently are 5980 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
CIRCUIT OPERATION
1-3) PB MODE
When playing the tape, the signal which is picked up from the tape is amplified 60 dB. Then luminance signal goes to pin 11 and color signal goes to pin 7 through AGC. Luminance signal of pin 11 is input to pin 39 of IC301 through PB EQ circuit in order to match playback characteristic. Color signal which is output from pin 7 of IC401 is input to pin 15 of IC301. PB FM signal is demodulated by IC internal demodulator then it is output to pin 3 after MAIN DE-Emphasis process. If this output signal has burst, color component will be separated by emphasis circuit. The signal which is input to pin 4 is output from pin 12 through 3.5M LPF, then it is input to pin 10 through 2H CCD. Color signal which is input to pin 15 passes ACC in order to stabilize level, then 4.43M components will be extracted by 4.43M BPF through Main Converter. This 4.4Mhz color signal removes crosstalk component through X302 and is input to pin 29 of IC301 then it will be mixed with luminance signal after passing CNR circuit. Finally Y/C composite video signal is output from pin 34.
X302 2H DLY
V-OUT
V.IN
IC301 VIDEO IC Y-EMPH
PB EQ
IC401 HEAD AMP
IC302 2H CCD
15
|
|
|
> |
|
