|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
Troubleshooting > Messages and Troubleshooting
Message
Disc is not formatted. Format the disc now? YES NO [Displayed only when DVDRW is used] All data will be deleted. Select record format. VR mode VF mode
Cause/condition for message to appear
Appears when a brand-new DVD-RW/ +RW was loaded.
Troubleshooting
Drive overheat. Please retry later.
DVD-R Disc, 16:9 mode cannot be changed, when Video mode is STD DVD-RW (VF) Disc, 16:9 mode cannot be changed, when Video mode is STD DVD+RW Disc, 16:9 mode cannot be changed, when Video mode is STD DVD-R Disc, Input Source cannot be changed. DVD-RW (VF) Disc, Input source cannot be changed.
When recording on the DVD video camera/recorder, choose �YES/ VR Mode/VF Mode� and designate it. Appears when reading or writing from/to Refer to �4-3-5 Cleaning disc and recorded �le cannot be performed optical pickup� and clean the disc. because the disc is dirty. Or replace the disc. May appear when a disc formatted and Use a PC, etc. to check the contents recorded on a device other than DVD on disc. video camera/recorders is loaded. Appears when an unformatted When initializing it (deleting all DVDRAM/DVD-RW/+RW or one recorded data), choose �YES� and initialized (other UDF2.0) on PC is designate it. loaded. Also appears if user rejects partial repair Choose �NO� and designate partial or total repair of video �le. repair or total repair. When initializing it (deleting all recorded data), choose �YES� and designate it. Appears when the temperature inside Set the power switch to �OFF� with the DVD video camera/recorder, or the the disc loaded, and then leave the temperature of disc, is too high, and DVD video camera/recorder in a normal operation cannot be executed. well-ventilated place until the inside temperature decreases. Appears when the wide-screen mode was Change the video quality to XTRA or chosen with the video quality set to STD FINE when using a brand-new DVDusing a DVD-RW (VF mode)/DVD-R/+RW: RW/DVD-R/+RW. If the DVD-RW/ The combination of STD (352 � 480 DVD-R/+RW has already been pixels) and wide-mode is prohibited by recorded in STD mode, replace it. the DVD video format.
Appears when an attempt was made to switch the input with a DVD-RW (VF mode)/DVD-R recorded in wide mode: Only the 4:3 aspect screen is possible for external input. This is because the DVD video format prohibits the mixing of 16:9 and 4:3 aspect screens. Appears when an attempt was made to change the video quality or wide mode of recorded DVD-RW (VF mode)/DVD-R. This is because, if even one scene is recorded after a disc is formatted, the speci�cations state that the video quality or wide mode used for the �rst recording will be held on the DVD-RW (VF mode)/ DVD-R.
Stop trying to switch the input, or replace the disc.
DVD-R Disc , Video mode and 16:9 mode cannot be changed. DVD-RW (VF) Disc, Video mode and 16:9 mode cannot be cheanged.
Stop trying to change the video quality or wide mode, or replace the disc.
4-8
|
|
|
> |
|
