|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
 ;
Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
;
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
l
l
l
If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary, turn the Freezer Control toward C. If you remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin, push it all the way in and lower the arm to the ON position. If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away They will be replaced. Cubes in the ice bin can also become smaller by evaporation.
l
Good water quality is important for good ice quality. It is not recommended that the ice maker be connected to a softened water supply Water softener chemicals such as salt from a malfunctioning softener can damage the ice maker mold and lead to poor quality ice. If a softened water supply cannot be avoided, then it is important that the water softener be well maintained and operating properly
Ice cube trays...
If cubes are not used, they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get. F ~~&t�,~both 2. Twist slightly. ends.
Removing the base grille...
To remove the grille:
the doors. 2. Pull grille outward as shown. 3. Do not remove Tech sheet fastened grille.
1. Open
To replace
behind
the grille:
clips.
1. Line up grille support tabs with metal 2. Push firmly to snap into place. 3. Close the doors.
Sounds you may hear...
Your new refrigerator may make sounds that your old one didn�t. Because the sounds are new to you, you might be concerned about them. Don�t be. Most of the new sounds are normal, Hard surfaces like the floor, walls and cabinets can make the sounds seem louder. The following chart describes the kinds of sounds that might be new to you, and what may be making them.
Poulble
l l
Sounds:
Probable
Causes:
fan motor and moving air.
Slight Hum, Sotl HISS: Cllcklng or Snapping Sounds: Water Sounds:
You may hear the refrigerator�s
The thermostat makes a definite click when the refrigeratorstops running. It also makes a sound when the refrigerator starts. The defrost timer will click when the defrost cycle starts and stops. When the refrigerator stops running, you may hear gurgling in the tubing for a few minutes after it stops. You may also hear defrost water running into the defrost water pan. If your refrigerator has an ice maker you may hear buzzing [from the water valve], trickling water and the clatter of ice dumped into the bin. Your refrigerator has a high-efficiency compressor and motor. It will run longer than older designs, It may even seem to run most of the time.
l
l
Ice Maker Sounds: - trickling water - thud (clatter of ice) Running Sounds:
l
8
|
|
|
> |
|
