This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Text excerpt from page 9 (click to view)
TIPS
l
l
l
l
l
The ice dispenser will work only with the freezer door closed. The ice dispenser will work only if the bin is pushed all the way in. Use only ice crescents from the ice maker. Other shapes won�t dispense properly. When you need more ice than a glass or two, scoop it from the bin or remove the bin. The dispenser motor may stop if the dispenser bar is held in too long. It will be ready to run again in about 3 minutes. Ice stored too long can go stale...like water. Throw it away.
to remove and empty the storage bin:
l
l
Ice can shrink. Cold moving air slowly evaporates them. If you use ice often, you may never notice the change. Good water quality is important for good ice quality. It is not recommended that the ice maker be connected to a softened water supply. Water softener chemicals such as salt from a malfunctioning softener can damage the ice maker mold and lead to poor quality ice. If a softened water supply cannot be avoided, then it is important that the water softener be well maintained and operating properly.
Plan
l
l
l
If the ice dispenser has not, or will not be used for a week or more. If a powerfailurecauses ice in the bin to melt and freeze together. If the ice dispenser is not used regularly.
1. Pull the covering
slide it to the rear.
panel
out from the bottom and
2. Lift the signal arm so it clicks into the OFF position. Ice can still be dispensed, but no more will be made.
3. Lift the front of the storage bin. Pull it out. 4. Empty the bin. Use hot or warm waterto melt the ice if necessary. Never use anything sharp to break up ice in the bin. This can damage the bin and dispenser mechanism. 5. Wash with mild detergent. Rinse well. Do not use harsh or abrasive cleansers or solvents. 6. When replacing the bin, make sure it is pushed in all the way. Push the signal arm down to the ON position to restart ice production.
