The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
Text excerpt from page 7 (click to view)
Removing Pull out to the stop, To remove 1. 2. 3. 4.
the crispers the crispers:
and crisper
cover
Slide the crisper straight out to the stop. Lift the front. Slide the rest of the way out. Replace in reverse order.
To remove the cover: 1. Lift front of cover off supports. 2. Lift out cover by pulling up and out. To replace the cover: 1. Fit back of cover in notch supports on walls of refrigerator. 2. Lower into place. NOTE: Glass cover will fit only above full width crisper. Crisper(s) must be removed before removing cover. Lift the cover the back. Adjusting the crisper humidity control You can control the amount of humidity in the moisture-sealed crisper. 1. The control can be adjusted to any setting between LOW and HIGH. 2. LOW (open) lets moist air out of crisper for best storage of fruits and vegetables with skins. 3. HIGH (closed) keeps moist air in the crisper for best storage of fresh leafy vegetables.
Removing Pull out to the stop, lift the front and pull again. To remove 1. 2. 3. 4.
the meat drawer the meat drawer:
and cover
Slide the meat drawer out to the stop. Lift the front. Slide the drawer the rest of the way out. Replace in reverse order.
To remove the cover: 1. Remove meat drawer and crispers. 2. Lift front of cover off supports. 3. Lift out cover by pulling up and out. To replace the cover: 1. Fit back of cover in notch supports on walls of refrigerator. 2. Lower into place. 3. Replace meat drawer and crispers.
