5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
Text excerpt from page 19 (click to view)
Something not working?
If the tumble dryer is not working correctly please carry out the following checks before calling an engineer. Symptom Possible cause The appliance is not plugged in The fuse has blown The tumble dryer will not start Solution Plug in the appliance Check the fuse
The START/PAUSE (START/PAUSE) Press the START/PAUSE (START/ button has not been pressed PAUSE) button No program has been selected The door is not properly closed The water reservoir is full The wrong program has been selected Fluff filter blocked Condenser covered with fluff The tumble dryer has been overloaded Laundry not sufficiently spun prior to tumble drying The vent in the base of the appliance is covered A residue may have formed on the drum interior, blocking the sensors Select the required program Close the door Empty the water reservoir Select a different program Clean the fluff filter Clean the condenser Observe the maximum loads stated for each program Ensure the wash load is well spun before tumble drying Ensure the vent is clear Clean the inside of the drum with white vinegar Clean the condenser unit Clean the fluff filter
The results are unsatisfactory
The condenser unit is covered with The drying process takes unusually fluff long Fluff filter is clogged The door cannot be closed Display EMPTY WATER (BEH�LTER) is lit
Fluff filter has not been inserted cor- Replace the fluff filter and ensure rectly and/or the filter lid not closed the filter lid is closed Condensate container full Empty the condensate container
With the container pulled out, switch Foreign bodies, e. g. animal hairs, EMPTY WATER (BEH�LTER) indion the appliance momentarily. The can block the inlet nozzle as well as cator illuminated, even though the blockage can be removed from the the valve on the end of the concontainer has already been emptied container shaft or the hair cleaned tainer out of the valve The dryer terminates the drying process automatically: END (ENDE) is displayed shortly after program start The drying process takes unusually long. 4.5 hours after the beginning of the drying process: - END (ENDE) display is illuminated - acoustic signal sounds - discontinuation of the drying process - program run display is flashing Too dry or too little laundry filled-in for the selected program Select time program or higher drying stage (e.g. EXTRA DRY (EXTRATROCKEN) instead of VERY DRY (STARKTROCKEN)) Check the program selection: SPECIAL CARE (SCHON) button appropriate only for laundry amounts up to 2.5kg Reduce the amount of laundry filled-in Pre-dry the laundry more thoroughly
SPECIAL CARE (SCHON) button pressed and too much laundry filled-in Too much laundry filled-in Laundry too damp
If you do not find the required information in this manual to remedy a disturbance, please call the customer service. 19
