My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
Text excerpt from page 5 (click to view)
Special accessories
Active carbon filter
When the hood is used in recirculation mode an active carbon filter should be used. Order by the retailer PNC 942 120 180
Installation
Unpacking
Check that the cooker hood has no damages. Transportation damages should immediately be reported to the one responsible for the transport Damages, faults and eventually missing details should immediately be reported to the seller. Take care of the packing material so that small children cannot play with it.
Min 60 cm
Min 70 cm
Placement
The hood is to be mounted on the wall or under a wall cupboard. When installed, the hood must be not less than 60 cm. above electric burners or 70 cm. above gas or mixed-fuel burners. (Fig. 4). Fig. 4
H I H I
OPEN
Electrical connection
The hood has a power cord with moulded plug with earth connection to be connected to a wall outlet of 230 V. The power cord length is 1 m.
H
Mounting of hood on wall
l Fix the drilling template to the wall (Fig. 5). l Make 3 � 8 mm holes in the wall. 2 at points H, 1 as desired at points I. l Insert the three � 8 mm expansion plugs into the wall. l Insert 2 5x45 screws at points H but do not tighten them completely. l Open the grid. l Fit the hood into holes H, tighten the 2 screws.
CLOSED
I
H I
I
H
Fig. 5
H I
l From inside the hood, insert the third 5x45 screw into hole I (Fig. 6). 5
