Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
Text excerpt from page 16 (click to view)
BUILDING-IN
Building-in features
This dishwasher is designed to be fitted under a kitchen counter or sink. In either case, it is essential that the recess dimensions indicated in the picture are followed. No further openings for venting of the dishwasher are required, but only to let the water fill and drain hoses and power supply cable pass through.
600
* 550 *
Mounting of decor panel onto the door The height of the panel depends on the height of the plinth of adjacent kitchen units (see kitchen plinth adjustment).
596 max
818÷878
820÷880
596
The panel must be fitted with a handle, as the dishwasher handle will be hidden by the panel. Drill the panel with a � 2x12 bit according to the dimensions indicated in the figure.
555x ma
II19
II28
II06
Fix the cross bar onto the panel using four 3.5x16 screws provided. Reduce the length of fixing screws according to thickness of panel. If for aesthetic matching the panel is provided with a false drawer (fitted or carved on the panel itself), the two brackets provided should also be used.
596 max 546 =
0 ÷ 60mm
The recess height may be anywhere between 820 and 880 mm from the floor since the dishwasher incorporates levelling feet adjustable over a wide range (max 60 mm). Adjust the height of the appliance by turning these feet. A distance of 2 mm should be allowed between the top of the dishwasher and the counter top.
=
30 40
Fix the brackets according to the measurements shown in the figure, by using four 3.5 x 16 screws.
30
Fitting under a counter (kitchen worktop or sink)
II17
It is absolutely essential that the dishwasher is disconnected from the electricity supply before gaining access to any internal component. Fit the dishwasher into the appropriate housing space and connect it. Make sure that the water fill and drain hoses and the power supply cable are not bent or kinked.
Reduce the length of fixing screws according to thickness of panel. Mount the decor panel by inserting the two pivots of the cross-bar into the slotted holes of the door. Lift the decor panel until perfect alignment with the facia panel is obtained: if the two brackets have also II12 been used, they will automatically enagage in the special holes provided on the dishwasher door. Once the correct position has been found, open the door and fasten the decor panel on the lower section by means of the two long 4x40 screws provided, using the holes through the inner door (see fig.).
II10
Fitting the panel onto the door
The door on this model is designed for the overlay of a panel having the following dimensions: Width: Height: Thickness: Weight: Note: The panel height should not be more than what indicated, otherwise complete opening of the door will no longer be possible as the panel hits against the dishwasher plinth. 596 mm 644 to 714 mm max 20 mm max 2 to 7.5 kg max
