|
|
|
Who's Online
There currently are 5660 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
 ;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
: Re.rn6~iiig.the�xrispe�rc To remove Pull out lo the slop, llfl the front nd pull again. the crisper%: 1. Slide cnsper strarght out lo the slop, lrfl front. then slrde out the rest of the way. 2. Replace in reverse order.
Remove the glass insert, lift the frame front, then the back.
Removing the crisper cover (Models ETPOGM, ETSOGK and ETZONK) To remove the cover: 1. Push up glass insert from bottom, then slrde out with both hands. 2. Lift lront of cover frame. 3. Lift out cover frame by pullrng up and out. 4. Remove metal cover support. To replace the cover: 1. Replace metal support on wall supports In from sectron of cabinet. 2. Frt back corner into notch supports on walls of refrigerator. then lower into place 3. Slide back of glass insert into place, then lower front.
Remove the glass Inset-& lift the frame front.
Removing the crisper cover (Models ET18GK, ET18HM and ET18HK) To remove crisper cover: 1. Push up glass Insert from the bottom, then slide out with both hands. 2. Lift front of cover frame and remove cover support. 3. Lift out cover frame by pulling up and out. To replace crisper cover: 1. Fit back of cover into notch supports on walls of refrigerator, then lower front into place. 2. Insert cover support (with the long tab toward the front) into the groove on the underside of the crisper cover. NOTE: If support needs adjustment, turn base clockwise to raise, or counter-clockwise to lower. 3. Slide back of glass Insert into place, then lower front.
9
|
|
|
> |
|
