|
|
|
Who's Online
There currently are 5960 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Adjusting
the refrigerator
shelves...
GUIDE STOP SHELF STOP
To remove the shelves: 1. First, remove food from shelf. 2. Slide shelf straight out to the stop. 3. Lift front, slide shelf the rest of the way out. To replace the shelves: 1. Fit back of shelf on top of guides on the bottom of guides.
with wire stops guide stops.
SHELF GUIDE
2. Lift front, slide shelf in until it clears
Removing crispers and crisper cover...
To remove the crispers: 1. Slide crisper straight out to the stop, lift front, then slide the rest of the way out. 2. Replace in reverse order. To remove the cover: 1. Lift front and remove the cover support. 2. Lift out cover by pulling up and out. To replace the cover: 1. Fit back of cover into notch supports on walls of refrigerator, then lower front into place. 2. Replace cover support with the long tab toward the front. NOTE: If the support needs adjustment, turn base right to raise, or left to lower.
LlFl THE FRONT, THEN THE BACK.
-
PULL OUT TO THE STOP. HE FRONT AND PULL AGAIN.
Changing the light bulb...
1. Reach behind the control console 2. Remove bulb. 3. Replace with a 40-watt appliance
to find bulb bulb.
Reversing the door swing...
You can change the hinges on your refrigerator so the doors open the other way. You will need a #20 Torx head screwdriver. Refer to the instruction sheet included with your refrigerator.
Ice cube trays...
(Model ETISJK only) 1. Hold tray at both ends If cubes are not used, they may shrrnk. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.
6
|
|
|
> |
|
