WHIRLPOOL ET18JMYSF0C
Owner's Manual

Adjusting

the refrigerator

shelves...
GUIDE STOP SHELF STOP

To remove the shelves: 1. First, remove food from shelf. 2. Slide shelf straight out to the stop. 3. Lift front, slide shelf the rest of the way out. To replace the shelves: 1. Fit back of shelf on top of guides on the bottom of guides.

with wire stops guide stops.

SHELF GUIDE

2. Lift front, slide shelf in until it clears

Removing crispers and crisper cover...
To remove the crispers: 1. Slide crisper straight out to the stop, lift front, then slide the rest of the way out. 2. Replace in reverse order. To remove the cover: 1. Lift front and remove the cover support. 2. Lift out cover by pulling up and out. To replace the cover: 1. Fit back of cover into notch supports on walls of refrigerator, then lower front into place. 2. Replace cover support with the long tab toward the front. NOTE: If the support needs adjustment, turn base right to raise, or left to lower.
LlFl THE FRONT, THEN THE BACK.

-

PULL OUT TO THE STOP. HE FRONT AND PULL AGAIN.

Changing the light bulb...

1. Reach behind the control console 2. Remove bulb. 3. Replace with a 40-watt appliance

to find bulb bulb.

Reversing the door swing...
You can change the hinges on your refrigerator so the doors open the other way. You will need a #20 Torx head screwdriver. Refer to the instruction sheet included with your refrigerator.

Ice cube trays...
(Model ETISJK only) 1. Hold tray at both ends If cubes are not used, they may shrrnk. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.

6