|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fast service, document is OK. Thanks! Searched for it long time.
 ;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
;
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Removing- the base grille... To remove the grille: r
METAL CLIPS -I SUPPORT TABS
1. Open the door. 2. Pull grille outwards as shown. 3. Do not remove Tech sheet fastened grille.
behind
To replace the grille: 1. Line up grille support tabs with metal 2. Push firmly to snap into place. 3. Close the door
clips.
Ice compartment
door.. .
Pull the Ice compartment door panel bottom and slide it to the rear
out from the
Ice cube trays...
(Model ETZORK only) If cubes are not used, they may shrink The movrng cold air starts a slow evaporation. The longer cubes are stored, the smaller they get. To remove ice: 1. Hold tray at both ends. 2. Slightly twist.
Automatic
ice maker...
If you have Model ET20RM with the automatic ice maker accessory, or if you have Model ET20RK and plan to add one later (Part No. ECKMF-831, there are a few things you will want to know:
l
l
LOWER SIGNAL ARM TO START IT
l
l
The dial or lever on the side of the ice maker changes the size of the cubes. Shake the bin occasionally to keep cubes separated, and to obtain increased storage CapaCitY It is normal for ice crescents to be attached by a corner. They will break apart easily. You will hear water running when ice maker is working. You�ll hear ice fall into the bin. Don�t let these sounds bother you. The ice maker will not operate until the freezer IS cold enough to make ice. This can take overnight. Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice. If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary, turn the Freezer Control toward A
l
l
The ON/OFF lever is a wire signal arm Down...for making ice automatically. Up...to shut off the ice maker. DO NOT TURN ICE MAKER ON UNTIL IT IS CONNECTED TO THE WATER SUPPLY.
l
l
|
|
|
> |
|
