The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
Text excerpt from page 9 (click to view)
Adjusting
the
EZ-TrackTM
refrigerator
shelf
The EZ-Track shelf slides from side to side for more flexible storage in your refrigerator. To slide shelf side-to-side: 1. Lift slightly on shelf front. 2. Slide to desired location. 3. Lower shelf front to level position. NOTE: You do not have to remove small items from the shelf before moving it side-to-side. You may need to remove larger items. /
Lif-l front slightly then slide to new location. Upper channel
To remove
the shelf:
1. Remove all items from the shelf.
2. Hold back of shelf with one hand. 3. Lift front of shelf to 45� angle. 4. Lower shelf slightly to release shelf from upper channel of track. Then pull shelf straight out. NOTE: Shelf is heavy. Make sure you use both hands when removing shelf.
Hold with both hands and lift front to 45� angle.
To remove shelf track: 1. Lift both sides of track slightly. 2. Pull track straight out.
Hold both sides and lift up and out.
To replace shelf track: 1. Guide track hooks into the shelf support slots on the back wall of the cabinet. NOTE: Make sure both track hooks are in slots and that the slots are parallel to each other. 2. Push track backward and down. 3. Check that track is completely seated in the shelf supports.
Make sure both sets of hooks are in support slots.
