Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
Text excerpt from page 17 (click to view)
7. OPTIONAL! Select, if required, �DELAY START� option button
Push �DELAY START� button as many times as necessary until the corresponding light to the required delay (12H, 8H, 4H y 2H) comes on.
10. Interrupting a programme
Depress INICIO / PAUSA button to interrupt a running programme, the corresponding light will begin flashing. Press this button again to re-start the programme.
11. Opening the door after the programme has started
Firstly, stop the machine by pressing INICIO / PAUSA button. After about two or three minutes the door can be opened. If the door does not open , this means that the temperature of the water is too high, that the water level exceed the lower limit of the door (which could cause overflowing) or that the drum is spinning. If the door cannot be opened but you need to open it, switch the machine off by turning the selector dial to �O�. After approximately two or three minutes the door can be opened. (PAY ATTENTION TO THE WATER LEVEL AND TEMPERATURE!)
8. Start the machine
Before starting the machine check that: � the appliance is plugged in. � the water supply tap is turned on. � the drain hose is correctly and securely positioned. � the door and the detergent dispenser drawer are closed. To start the selected programme, push INICIO / PAUSA button; the corresponding light will stop flashing and will remain lit until the end of the programme.
12. At the end of the programme
The machine stops automatically. Release of the lock is indicated when FIN light comes on. Turn the programme selector dial to position �O� to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to put in another wash, turn off the water tap. Leave the door open to prevent from forming mildew and unpleasant smells. ATTENTION!
If �DELAY START� option has been chosen, the machine will begin the countdown.
If the RINSE HOLD option has been selected, the last rinse water does not drain. To drain the water, carry out the following steps: 1. Turn the programme selector dial to �O�. 2. Select DRAIN or SPIN programme. If programme (SPIN) has been selected: Use the spin speed selector dial to choose the required speed. If the dial is kept in the same position as at the beginning, in other words RINSE HOLD (no-wrinkle) position, the machine will spin at 400 r.p.m. 3. Press INICIO / PAUSA button
9. Modification of a running washing programme
Once the programme has started, it only can be modified by turning the programme selector dial to �O� and afterwards the new programme can be chosen. The washing water remains in the tub, provided that the machine does not reach the rinse phase, since, in this case, the machine drains it automatically. Start the new programme by pressing INICIO / PAUSA button.
