|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
;
Very good scanning quality. All schematics are very legible. Worth every cent !
;
Excellent quality, very quick download turnaround, will definately use again.
2-9. Using the Extension Board
2-9. Using the Extension Board
The extension board is provided with the FVS-P1000 for checking and adjusting the processor board. . Extension board (EX-632): . Extension board (EX-670): A-8320-763-A A-8320-764-A For extending the board in front of the processor For extending the board at the rear of the processor
Extending the Front Side Board 1. 2. 3. 4. Open the door at the bottom of the unit. Loosen the four screws, and remove the front cover. (Refer to Section 2-8-1.) Open the eject levers at both ends of the board removed in the arrow direction. Holding the eject levers, pull out the board.
Eject lever
Eject lever
Board
5. Set the dip switches of the extension board according to the board extended. 6. Push in the extension board (EX-632) according to the guide rail. 7. Insert the board removed into the extension board.
Dip switches
Extension board (EX-632)
Processor board
2-36
FVS-1000 MMP1
|
|
|
> |
|
