Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
helpful manual.good service.Quick response.will use again
Text excerpt from page 53 (click to view)
Plumbing
Drainage
� The machine comes equipped with a built-in non-return valve on the discharge side to prevent waste water from flowing back into the dishwasher. � The dishwasher is equipped with a 5 ft (1.5 m) flexible drain hose with an internal diameter of 7/8" (22 mm). � Drain hose extensions and adapters can be ordered from Miele. The maximum drain hose length is 13 ft. (4 m), max. drain height: 39" (1 m). � If the hose is to be directly fitted to the drainage outlet on site, use the supplied hose clip. � The hose can be installed to the left or right side. � The existing drain pipe for the drain hose is designed for various hose diameters. The drain pipe must be shortened if the drain pipe extends too far into the drain hose. The drain hose could get clogged. � The drain hose must not be shortened. � Make sure the hose is installed without kinking, pressure or being pulled. ^ Cut off the vent cap located at the right rear of the triple filter system, as illustrated. Venting the drainage system If the dishwasher drain hose is connected to a floor drain or to a drain pipe that is less than 8" (20 cm) above the floor, the drain must be vented. Otherwise the water inside the dishwasher may siphon out during the wash program. ^ Open the dishwasher door and remove the lower basket. ^ Pull the lower spray arm firmly upwards to remove.
