This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
It was easy done, and I got exactly what I was looking for.
Text excerpt from page 50 (click to view)
Dishwasher installation
3. Installing the control panel.
The control panel and hardware is packaged separately from the dishwasher. It should be installed using the following procedure. If a GDU decor kit is being used, (to convert an �i� dishwasher to a �U� version), the spacer bars g must first be removed and stored for possible use in the future (See the separate instructions for installing the GDU decor kit). If the GDU kit is not being used, skip the following step. bolts from their slots. Install the number of spacer bars g required to align the lower edge of the control panel with the neighboring cabinet drawer line. Place the supplied seal c. ventilation grill
b onto the
Push the ventilation grill c into the metal backing plate. Place the control panel d over the backing plate and fasten it from the inside of the door e using the six screws provided. Align and press the program knobs onto their shafts f. To remove the spacer bars from the control panel, place the panel on a table, printed side up, and gently push down on the spacer bars at a point near the bottom of the control panel. This will release the mounting
50
