|
|
|
Who's Online
There currently are 5494 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
 ;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
3.2.13 REMOVING THE TEMP PWB (Fig.2) � Remove the REAR COVER. (1) Pull out the TEMP PWB from the claw of the TOP FRAME. 3.2.14 REMOVING THE CONTROL PWB (Fig.2) � Remove the REAR COVER. (1) Remove the 2 screws [A]. (2) Remove the CONTROL KNOB. (3) Remove the CONTROL PWB from the TOP FRAME. 3.2.15 REMOVING THE CHASSIS BASE AND TOP FRAME (Fig.2) � Remove the REAR COVER. � Remove the BACK SHIELD. � Remove the SIDE SHIELD. � Remove the TERMINAL BRACKET. � Remove the BACK BRACKET. (1) Remove the 2 screws [B]. (2) Remove the CHASSIS BASE. (3) Remove the 2 screws [C] and the 2 screws [D]. (4) Remove the TOP FRAME. 3.2.16 REMOVING THE LED PWB (Fig.2) � Remove the REAR COVER. � Remove the BACK SHIELD. � Remove the SIDE SHIELD. � Remove the TERMINAL BRACKET. � Remove the BACK BRACKET. � Remove the CHASSIS BASE. � Remove the TOP FRAME. (1) Remove the 1 screw [E]. (2) Remove the LED PWB. 3.2.17 REMOVING THE LCD PANEL UNIT (Fig.2) � Remove the REAR COVER. � Remove the BACK SHIELD. � Remove the SIDE SHIELD. � Remove the TERMINAL BRACKET. � Remove the BACK BRACKET. � Remove the CHASSIS BASE. � Remove the TOP FRAME. (1) Remove the 2 screws [F] and the 2 screws [G]. (2) Remove the BOTTOM FRAME. (3) Remove the LCD PANEL UNIT from the FRONT PANEL.
1-14 (No.YA347)
|
|
|
> |
|
