4. When the display reads RECTWeeD, press the AMP SAVE button again. Now we need to choose one of the 9 User HyperModel� locations.The alpha-numeric display should read EMPTY (Empty) and the red numeric display should read U1 if this is the first HyperModel� stored to your GNX3. 5. Press the AMP SAVE button again to save to this Amp location.The display briefly reads AMP SaVD (Amp Saved) and then returns to the name of the selected preset.
Select Models for the Preset�s Channels
In the previous steps, we selected a Tweed amp model for the Green Channel and a Rectified amp model for the Red Channel. Then we Warped the two together to create our HyperModel�. This HyperModel� is saved as an amp type that we named Rectweed, but it is not currently part of our preset. In this example preset, we need to be able to toggle between an acoustic guitar simulation and our new HyperModel�. To do this we need to select the Acoustic model for the Green Channel and Rectweed for the Red Channel of our preset, as follows: 1. The LED next to the STATUS button should be yellow. If it is not, press EXIT. 2. Rotate the Parameter 1 knob until the display reads ACOUSTic.This is the Green Channel Model for the preset. 3. Rotate the Parameter 4 knob until the display reads RECTWeeD (our new HyperModel�). This is the Red Channel Model for the preset. This lets us toggle between these two sounds using the Amp Footswitch (when Stompbox Mode is active).
Edit the Preset
The next step to creating our example preset involves the editing the preset. To edit the preset, do the following: 1. Press the EFFECT SELECT DOWN button. The Matrix LED in the Wah-Pickup row lights. The display briefly reads EDIT and then cycles between the status of the Wah and Pickup Simulator effects. 2. If the red display reads WAH On, press the STATUS button once to turn the Wah off (since our example does not use a Wah).
