|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good manual. Plenty of service information including alignment instructions. Clear circuit diagram. Excellent, thank you.
 ;
Good morning, the service manual you sent me was perfect.
Your service and answering are excellent.
I recomend this service.
Best regards.
;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
;
Top quality manual. Covers all aspects you'd expect in a top quality service manual for this Panasonic VHS VCR. The manual resolution is high. Another top quality manual from the only site worth downloading manuals from! If you're looking for a manual for the PV-9662 VHS VCR, this is the one you'll want to get!
;
complete part-lists and pcb layout, schematic diagram is good enlargable,
2.1.5.3
[ 4 ] REEL DISK ASSY(SUP) [ 5 ] REEL DISK ASSY(TU) [ 6 ] REEL COVER ASSY
(W4) NOTE 4 [4] 8 (S6a) (W5a) NOTE 5a [5] (W5b) NOTE 5b (W6) 10 (S6b) 9 (S6a)
NOTE 4: Be careful not to attach the REEL DISK wrongly. The Supply side can be identified by the white color at the center. NOTE 5a: Be careful not to attach the REEL DISK wrongly. The Take-up side can be identified by the black color at the center. NOTE 5b The washer is inserted under the REEL DISK. Be carefull not to lose the washer. Two washers are inserted under the REEL DISK in some products manufactured earlier, but one washer is inserted in the products manufactured recently and in the future. See the parts list, and use the parts written in the parts list. NOTE 6: Perform the following steps for mounting. (1) Align the hole with the pin. (2) Attach the [17] PINCH ROLLER ARM FINAL ASSY by aligning the positions. (3) Attach the SLIDE DECK ASSY (POINT[A]) by aligning the positions. (4) Check that the parts below them are located in the correct positions. (5) Tighten the 2 screws. (6) Tighten the screw. (7) Attach the 1 SLIT WASHER parts.
NOTE 4, 5 NOTE 6
(3) (5) (2),(6)
[6] NOTE 6 [ 17 ]
Fig.2-1-16
REEL DISK ASSY
WHITE BLACK
[A] (4)
SUP TU
(1), (7)
2-8 (No.86700)
|
|
|
> |
|
