|
|
|
Who's Online
There currently are 6015 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
 ;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
EN
� To deactivate the selected effect, press EFFECT ON/OFF. To reactivate the selected effect press EFFECT ON/OFF again. � To change the selected effect, repeat from step 2 above.
59
Audio Dubbing
The audio track can be customised only when recorded in the 12-bit and SP modes. ( pg. 34)
Headphone Connector Stereo Microphone
Speaker
NOTES: � When editing onto a tape that was recorded at 12-bit, the old and new soundtracks are recorded separately. � If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas. � If feedback or howling occurs during TV playback, move the camcorder�s microphone away from the TV, or turn down the TV�s volume. � If you change from 12-bit to 16-bit in midrecording and then use the tape for Audio Dubbing, it is not effective from the point where 16-bit recording began. � During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in 16-bit audio or a blank portion, Audio Dubbing stops. � To perform Audio Dubbing while watching on the television, make connections. ( pg. 22) � To perform Audio Dubbing with a video unit connected to the camcorder�s AV connector, first set �S/AV INPUT� to �ON� in VIDEO Menu. ( pg. 31, 40) The �AUX� indication appears instead of �MIC�.
A.DUB PLAY PAUSE STOP
1 2 3 4
Play back the tape to locate the point where editing will start, then press PAUSE (9). While holding A. DUB (D) on the remote control, press PAUSE (9). The �9D� and �MIC� indicators appear. Press PLAY (U), then begin �narrating�. Speak into the microphone. � To pause dubbing, press PAUSE (9). To end Audio Dubbing, press PAUSE (9), then STOP (8).
To hear the sound during Audio Dubbing... Connect optional headphones to the headphone connector or use the AV connector, and set the �12bit MODE� to the desired mode; � �SOUND 1� for the playback sound. � �SOUND 2� for the dubbed sound. � �MIX� for the playback and dubbed sound. To hear the dubbed sound during playback� Set �12bit MODE� to �SOUND 2� or �MIX�. ( pg. 31, 40)
ADVANCED FEATURES
|
|
|
> |
|
