Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
Text excerpt from page 10 (click to view)
10 EN
Power Zoom Lever
GETTING STARTED (cont.)
Grip Adjustment
Recording Start/Stop button
1 Separate the Velcro strip. 2 Pass your right hand through the loop and grasp the grip. 3 Adjust your thumb and fingers through the grip, to
easily operate the Recording Start/Stop button and Power Switch and Power Zoom Lever. Be sure to fasten the Velcro strip to your preference.
Power Switch
Viewfinder Adjustment
Dioptre Adjustment Control
1 Set the Power Switch to � AUTO � or � MANUAL �
while pressing down the Lock Button located on the switch.
2 Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
PAUSE
Shoulder Strap Attachment
1 Make sure the battery pack is removed. Following
2 1 3
the illustration, thread the strap through the eyelet 1, 2. then fold it back and thread it through the buckle Repeat the procedure to attach the other end of the strap to the other eyelet 3 located under the Grip Strap . Confirm the strap is not twisted.
Tripod Mounting
CAUTION
When attaching the camcorder to a tripod, extend its legs to stabilise the camcorder. It is not advised to use small sized tripods. This may cause damage to the unit by falling over.
1 To attach the camcorder to a tripod, align the
direction stud and screw to the mounting socket and stud hole on the camcorder. Then tighten the screw clockwise. Some tripods are not equipped with studs.