|
|
|
Who's Online
There currently are 5584 guests and
13 members online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
8
EN
BAT. RELEASE Switch
GETTING STARTED (cont.)
Power
This camcorder�s 2-way power supply system lets you choose the most appropriate source of power. Do not use provided power supply units with other equipment.
1 2 3
Power Switch
CHARGING THE BATTERY PACK
1 2 3 4
Battery pack
Tilt the viewfinder upward 1. With the arrow on the battery pack pointing downward, push the battery pack slightly against the battery pack mount 2, then slide down the battery pack until it locks in place 3. Set the Power Switch to �OFF�. Connect the AC Adapter to the camcorder 4, then connect the Power Cord to the AC Adapter 5. Plug the Power Cord into an AC outlet 6. The CHARGE lamp on the camcorder blinks to indicate charging has started. When the CHARGE lamp stops blinking but stays lit, charging is finished. Unplug the Power Cord from the AC outlet. Disconnect the AC Adapter from the camcorder.
CHARGE Lamp
AC Adapter
To Detach The Battery Pack . . .
.... slide BAT. RELEASE and pull out the battery pack. NOTES: � If the protective cap is attached to the battery pack, remove it first. � During charging, the camcorder cannot be operated. � Charging is not possible if the wrong type of battery is used. � When charging the battery pack for the first time or after a long storage period, the CHARGE lamp may not light. In this case, remove the battery pack from the camcorder, then try charging again. � If the battery operation time remains extremely short even after having been fully charged, the battery is worn out and needs to be replaced. Please purchase a new one. � Using the optional AA-V40 AC Power Adapter/Charger, you can charge the BN-V408U/V416U/V428U battery pack without the camcorder. However, it cannot be used as an AC adapter.
5
4 To DC
connector
6 To AC outlet
Battery pack BN-V408U BN-V416U (optional) BN-V428U (optional) Charging time approx. 1 hr. 30 min. approx. 2 hrs. approx. 3 hrs. 20 min.
For other notes,
pg. 71
|
|
|
> |
|
