5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
very helpful, the information in these manuels are very detailed
Text excerpt from page 68 (click to view)
68
EN
TROUBLESHOOTING (Cont.)
POSSIBLE CAUSES
11. �Depending on the light source, the 1/25 shutter speed may be deactivated in order to reduce the shakiness in the picture. 12. �The Squeeze mode is selected. 13. �"PHOTO FRAME" is set to "OFF" in the system menu. �The Cinema mode is engaged, disabling the white border. 14. �10X optical zoom is selected. �The Video Echo effect is activated. �Picture Wipe or Dissolve are being used in a scene transition. �5-Second recording was done with the Power Dial set to �5S�, and with �5SD� selected in the System Menu. �Snapshot Dissolve was attempted during Digital Zoom. 15. �The Power Dial is set to � A �. �The Power Dial is set to �5S�. 16. �The Sepia or Monotone effects are activated. 17. �P.AE/Effects Sepia, Monotone or Slow are activated. �The Squeeze mode is selected. �The previously selected P.AE/Effect was changed after the last selected scene for editing was registered. 11.
����
SYMPTOM
11. Even though �GAIN UP� was set to � A �, scenes shot in dark places are not brightened. 12. Snapshot mode cannot be used. 13. Although the SNAPSHOT button is pressed, the white border does not appear. 14. Digital Zoom doesn�t work.
CORRECTIVE ACTION
12. � Disengage the Squeeze mode ( pg. 31). 13. � Set �PHOTO FRAME� to �ON� in the system menu ( pg. 35). � Disengage the Cinema mode ( pg. 31). 14. � Turn off the Video Echo effect ( pg. 43). � Wait until the Picture Wipe or Dissolve effects are completed ( pg. 38). � Change the setting of either the System Menu or the Power Dial ( pg. 34). � Do not attempt to take a Snapshot when performing Digital Zoom ( pg. 25).
15. P.AE/Effects and Fade/ Wipe Effects don�t work.
15. � Set the Power Dial to � M � ( pg. 18). � Change the setting of the Power Dial. 16. � Turn off Sepia and Monotone ( pg. 42). 17. � Turn off Sepia and Monotone before adding Dissolve to a scene transition ( pg. 42). � Make sure that the Squeeze mode in the Recording Menu is set to �OFF� ( pg. 30). � Make sure you have selected the P.AE/Effects you want before starting editing ( pg. 42). 18.
16. The Black & White Fader doesn�t work. 17. The Dissolve function doesn�t work.
18. Scene transition does not go as expected.
18. �When using �Picture Wipe/ Dissolve� ( pg. 38) or �Dissolves during 5 second mode recording� ( pg. 28), there is a delay of a fraction of a second between the previous record stop-point and the Dissolve start-point. This is normal, but this slight delay becomes especially noticeable when shooting fast-moving subject or during rapid panning.
