Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Text excerpt from page 49 (click to view)
6. SETTING AND ADJUSTMENTS BEFORE SHOOTING
6-5 Back Focus Adjustment
3. 4. 6. 5.
It is only necessary to perform this when the lens is attached for the first time or when focusing is not correct in both the telephoto and wide-angle positions. It is easier to adjust back focus when the subject is more than 3 meters from the camera. The optimal subject for this adjustment is a Siemens star chart.
RET
M A
1. Set the IRIS mode switch to M (Manual). 2. Set the zoom mode to M (Manual). 3. Open the iris by turning the iris ring. If the illumination is too
W
T
1.
strong, reduce it or move to a darker place.
4. Turn the zoom lever until the lens is at the maximum
telephoto position.
MACRO
2.
7. 8. 10.
5. Bring the subject into focus. 6. Set the lens to maximum wide-angle. 7. Loosen the back focus ring retaining knob. 8. View the same subject and adjust the back focus ring for
the best possible focus.
9. Repeat steps 4. through 8. about three times for fine
adjustment until the subject remains in focus in both the telephoto position and the wide-angle position.
10.Tighten the back focus ring retaining knob to secure the
ring.
MEMO:
ACCU FOCUS can also be used in the above step 3.
