|
Who's Online
There currently are 5973 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
HCD-GTX66/GTX77
[CD SERVICE MODE]
� This mode let you move the CD sled motor freely. Use this mode when you want to clean the optical pick-up. Procedure: 1. Press ?/1 button to turn on the system. 2. Select CD function. 3. Press x button, [ENTER] button and [OPEN/CLOSE] button simultaneously. 4. The CD service mode is activated. The message �SERVICE MODE� appears on the fluorescent indicator tube. 5. With the CD in stop status, press M to move the optical pick-up to outside track, or turn m to move to inside track. The message �SLED OUT� or �SLED IN� appears on the fluorescent indicator tube. 6. To turn on or off the laser, press [FLANGER] button. The message �LD ON� or �LD OFF� appears on the fluorescent indicator tube. 7. To release from this mode, press ?/1 button to turn off the system.
� Aging mode sequence:
START
DISC CHUCKING
TOC READING
PLAY FIRST TRACK FOR 2 SECONDS
[CD AGING MODE]
� This mode can be used for operation check of CD section. If an error occurs, the aging operation would stops and the status is displayed. If there were no error occurs, the aging operation would continue repeatedly. Procedure: 1. Press ?/1 button to turn on the system. 2. Select CD function. 3. Load three discs on disc tray. 4. Press [PLAY MODE/TUNING MODE] button on the remote control repeatedly to select the �ALL DISCS� mode, and press the [REPEAT/FM MODE] button on the remode control repeatedly to select repeat mode off. 5. Press x button, [ENTER] button and [DISC SKIP/EX-CHANGE] button simultaneously. 6. Aging operation is started. 7. To release from this mode, press ?/1 button or disconnect the power cord to turn the power OFF.
PLAY LAST TRACK FOR 2 SECONDS
EX-CHANGE OPEN/CLOSE
OPEN THE DISC TRAY
DISC SKIP
CLOSE THE DISC TRAY
CHANGE THE NEXT DISC
24
|
|
|
> |
|