|
|
|
Who's Online
There currently are 5212 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
;
The manuel was exactly what I needed and I received it promptly. Thanks
;
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
ENGLISH
5
Using the kettle
C
1 2
Wind excess mains cord around the base of the appliance. Put the base with the kettle on a cool, flat surface, out of the reach of children and put the plug in the wall socket.
Only use the kettle in combination with its original base. 3 Take the kettle off its base. Fill the kettle with water through the spout.
C
4
Never fill the kettle while it is standing on its base.
2
1
C
� You can also open the lid to fill the kettle. Do not put less than 0.1 litre of water in the kettle. - If the kettle boils dry, it will switch off automatically but the On/Off switch will stay in the "I" position. After 10 minutes the kettle must be lifted off the base to reset its dry-boil protection, you can use the kettle again. Do not fill the kettle beyond the 'MAX' indication. - If too much water has been put in the kettle, boiling water may be ejected from the spout. 5 Close the lid and put the kettle on its base.
Make sure the lid is properly closed, otherwise the kettle will boil dry.
C
6 Set the On/Off switch to position "I". The kettle starts heating up. The appliance switches off automatically when the water has reached the boiling point. The On/Off switch returns to the "O" position. 8 You can interrupt the boiling process by setting the On/Off switch to "O". 7
|
|
|
> |
|
