|
Categories
|
Information
|
Featured Product
|
|
|
 |
|
There are currently no product reviews.
 ;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
 ;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
 ;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
 ;
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
Instructions for Installation
Removing the Old Water Heater
@ Disconnect the vent pipe from the draft hood or blower assembly where they connect to the water heater. In most or other attached devices can be lifted off new water instaUations the vent pipe are removed. The after any screw heater has a blower assembly which must be used for proper operation. a. If you have copper piping to the water heater, the two copper water pipes can four inches away from where they connect to the water heater. This will @ @ @ @ avoid cutting offthe pipes too short. Additional cuts can be made later if necessary. Disconnect the temperaturepressure relief valve drain line. When the water heater is drained, disconnect the hose from the drain valve. Close the drain valve. The water heater is now completely disconnected and @ ready to be removed. Turn "OFF" the gas supply to the water heater.
_, WARNING
]
If the main gas line shutoffservingall gasappliances used, is I also shut "OFF",thegas at eachappliance, eaveall gasappli-| L ances shut"OFF unt_ thewater heaterinstallation iscomplete.I
cutw ka po
Turn "OFF" the water to the water heater. Some installations require that the water be turned offto the entire house.
Check again to make sure the gas supply is "OFF" to the water heater. Then disconnect the gas supply connection from the gas control valve, Attach a hose to the water heater drain valve and put the other end in a floor drain or outdoors. Open the water heater drain valve. Open a nearby hot water faucet which will relieve pressure in the water heater and speed draining,
@
b. If you have galvanized pipe to the water heater, loosen the two galvanized pipes with a pipe wrench at the union in each line. Also disconnect the piping pieces should be water heater. These remaining to the saved since they may be needed when reconnecting the new water heater. Disconnect the temperature-pressure refiefvalve drain line. When the water heater is drained, disconnect the hose from the drain valve. Close the drain valve. The water heater
_._
readyiS completely disconnected nowandto removed. be
AWARNING
thatthe waterflow isdirectedawayfrom anyperson.
I
I 8
ACAUTION
Mineralbuildupor sedimentmay have accumulated the old in water heater.Thiscauses water heater to be muchheavier the than normalandthis residue, spilledout,couldcause if staining.
Thewater passing of the drainvalvemaybe extremelyhot. out Toavoidbeingscalded, akesureall connectionsre tight and I m a
|
|
 |
> |
|