|
|
|
Who's Online
There currently are 5968 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
manual was very helpful in learning how to propery use my washer. I could not find this manual anywhere else.
 ;
Awesome quality manual. You really saved my bacon with this one. Was looking for some specific information with regards to my "new" vintage VCR that didn't come with the owners manual. This site is truely a goldmine of available manuals. The quality of the scans are top notch.
Thank-you so much for this awesome manual. If you're looking for this Sony SL-HF400 owners manual, this is the one you NEED to buy. Definitely worth the money.
;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
Instructions for Installation
Removing the Old Water Heater
O Turn "OFF" the gas supply to the water heater. Q Disconnect the vent pipe from the draft hood where they connect to the water heater. In most installations the vent
A WARN ING
If the main gas line sh_gas appliances used,/ is l also shut %ff" the gas at eachappliance.Leaveall gasappli-| ances shut =off*untilthe waterheaterinstallation iscomplete. ] devices are removed, Dispose of the draft hood, The new water heater has the draft hood which must be used for pipe can be rifted proper operation. off after any screw or other attached G a. If you have copper piping to the water
Q
Q
four inches away from where they connect to the water heater. This will be cut with a hacksaw approximately avoid cutting off the pipes too short. necessary. Disconnect the temperatureheater, the two copper water pipes can pressure refiefvalve drain line. When Additional cuts can be made later if the water heater is drained, disconnect
QTurn
"OFF" the water to the water _
heater. Some installations require that the water be turned offto the entire house. (_
the hose from the drain valve. Close the drain valve. The water heater is now completely disconnected and ready to be removed.
Check again to make sure the gas supply is "OFF" to the water heater. Then from the gas control valve.
I_
tal_
Q
b. If you have galvanized pipe to the water with a pipe wrench at the union in each
_) Q Attach a hose to the water heater drain valve and put the other end in a floor disconnect the gas supply connection drain or outdoors. Open the water heater drain valve. Open a nearby hot water faucet which will relieve pressure in the water heater and speed draining, _, __
fine. Also disconnect the piping remaining tO the water heater. These pieces should be saved since they may be needed when reconnecting the new heater, loosen the two galvanized pipes water heater. Disconnect the temperature-pressure relief valve drain line. When the water heater is drained, disconnect the hose from the drain valve. Close the drain valve. The water heater ready to be removed.
WARNING The water passing of the drainvalvemaybe extremely out hot. To avoidbeing scalded, akesureall connectionsre tight and m a that thewaterflow isdirectedawayfrom anyperson, 9
A, CAUTION Mineral buildupor sedimentmay haveaccumulated the old in water heater.Thiscauses water heaterto be muchheavier the thannormalandthis residue, f spilled i out, couldcause staining.
|
|
|
> |
|
