I purchased a vintage Sony mixer off eBay and within the hour was able to locate and purchase the manual for it.I mean really,where else can you find a manual for a product made in 1983!? It was easy to find and purchase/download the manual I needed.I will use this site again for other equipment I have! Great site!
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
Text excerpt from page 9 (click to view)
Recording
Use the following procedure to record TV programmes on a blank video tape.
Editing
Editing To/From Another Recorder
Player
Before proceeding:
� To record TV programmes, the video cassette player must be connected to the TV as shown in connection B of the �Connections� section. � Turn on the power of the TV and video cassette player. � Make sure that the video cassette�s safety tab is intact. If it has been removed, cover the hole with adhesive tape.
40 32 10-
RF OUT
K G AUDIO
IN
OUT
ANT. IN
1-
VIDEO
Audio/Video signals
1
INTELLIGENT PICTURE
OPERATE STANDBY
2
NTSC ON PAL TV NTSC3.58 NTSC4.43
PAL NTSC
- VOLUME + TV/VIDEO TVCH
TV
+ OPERATE
VIDEO
TV/VIDEO OPERATE
AUTO
- TRACKING +
2
(+
SP/LP/EP
NTSC 3.58/4.43
RECORDING & PLAYBACK
INTELLIGENT PICTURE
LP/EP
L
+(
40 32
10-
[
J
RF OUT
K G AUDIO
IN
OUT
ANT. IN
1-
VIDEO
REMOTE CONTROL UNIT
Recorder
1 2
Load a blank video tape. Press the Record ¶ button to start recording. (On the remote control unit press the Record ¶ and Play 3 button at the same time.) The recording indicator will light during recording.
TV Receiver VIDEO CHANNEL
1 2 3
Connect the player�s AUDIO and VIDEO OUT connectors to the recorder�s AUDIO and VIDEO IN connectors. Put the player in the Play mode. Put the recorder in the Record mode.
7 Press the Stop/Eject § button or the remote control�s Stop & button to stop recording. To stop recording temporarily: 7 Press the Pause 8 button. The recording indicator will blink. Press the Play 3 button to resume recording. Notes: � To engage recording standby, press the Record ¶ button and then press the Pause 8 button. The recording indicator will blink during recording standby. Press the Play 3 button again to start recording. � If the Record button does not work, check to see if the cassette safety tab has been removed. � The player automatically stops when record-standby continues for more than 5 minutes. � The video tape will be rewound automatically when the end of the tape is reached.
Notes: � NTSC tapes being played back in the NTSC PLAYBACK ON PAL TV mode cannot be dubbed to another recorder. � When you dub an NTSC tape using your recorder as the playback deck, select NTSC 3.58 (or 4.43) with the Colour System Output switch. Important: 7 To edit, both the player and the recorder must be of the same colour system. Press your recorder�s Colour system switch to select the appropriate colour system.
