JVC HR-S5980AH
Owner's Manual

MOISTURE CONDENSATION
� Cassettes marked �S-VHS� and �VHS� can be used with this video cassette recorder. However, S-VHS recordings are possible only with cassettes marked �S-VHS�. By using the S-VHS ET function, it is possible to record and play back with S-VHS picture quality on VHS cassettes with this recorder. � HQ VHS is compatible with existing VHS equipment. � G-CODE is a trademark of Gemstar Development Corporation and is registered in the following countries and areas: Australia, China, Hong Kong, Japan, South Korea, New Zealand, and Taiwan. SHOWVIEW is a trademark of Gemstar Development Corporation and is registered in the following countries: Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Hungary, Iceland, Italy, Luxembourg, Netherlands, Norway, Poland, Portugal, Russia, Slovakia, South Africa, Spain, Sweden and Switzerland. The G-CODE/SHOWVIEW system is manufactured under license from Gemstar Development Corporation. G-CODE and SHOWVIEW are different trademarks used to represent the same easy recording feature. However, for simplicity, only the term G-CODE will be used in the instructions. If you use SHOWVIEW system, follow the same steps listed for the G-CODE system. POWER SYSTEM This set operates on voltage of AC110 V � 240 Vd (Rating), AC90 V � 260 Vd (Operating), 50 Hz/60 Hz with automatic switching. The STANDBY/ON 1 button does not completely shut off mains power from the unit, but switches operating current on and off. �`� shows electrical power standby and �!� shows ON. Video tapes recorded with this video recorder in the LP (Long Play) or EP (Extended Play) mode cannot be played back on a single-speed video recorder. When the equipment is installed in a cabinet or a shelf, make sure that it has sufficient space on all sides to allow for ventilation (10 cm or more on both sides, on top and at the rear). When discarding batteries, environmental problems must be considered and the local rules or laws governing the disposal of these batteries must be followed strictly. Failure to heed the following precautions may result in damage to the recorder, remote control or video cassette. 1. DO NOT place the recorder � � in an environment prone to extreme temperatures or humidity. � in direct sunlight. � in a dusty environment. � in an environment where strong magnetic fields are generated. � on a surface that is unstable or subject to vibration. 2. DO NOT block the recorder�s ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may not be able to get out.) 3. DO NOT place heavy objects on the recorder or remote control. 4. DO NOT place anything which might spill on top of the recorder or remote control. (If water or liquid is allowed to enter this equipment, fire or electric shock may be caused.) 5. DO NOT expose the apparatus to dripping or splashing. 6. DO NOT use this equipment in a bathroom or places with water. Also DO NOT place any containers filled with water or liquids (such as cosmetics or medicines, flower vases, potted plants, cups, etc.) on top of this unit. 7. DO NOT place any naked flame sources, such as lighted candles, on the apparatus. 8. AVOID violent shocks to the recorder during transport.
A

Moisture in the air will condense on the recorder when you move it from a cold place to a warm place, or under extremely humid conditions�just as water droplets form on the surface of a glass filled with cold liquid. Moisture condensation on the head drum will cause damage to the tape. In conditions where condensation may occur, keep the recorder turned on for a few hours to let the moisture dry.

ATTENTION
TO MOBILE PHONE USERS: Using a mobile phone in the vicinity of the recorder may cause picture vibration on the TV screen or change the screen to a blue back display. ON PLACING THE RECORDER: Some TVs or other appliances generate strong magnetic fields. DO NOT place such appliance on top of the recorder as it may cause picture disturbance.

Installing/removing the lithium battery
Be sure to connect the power plug to an AC outlet first before installing the lithium battery; otherwise, the battery's service life will be drastically shortened. A Make sure that the power plug is connected to an AC outlet and turn off the recorder power. B Open the battery cover while pressing the release tab as illustrated. C Insert a lithium battery with the plus (+) side up and push it in. � To remove the lithium battery, press the latch downward using a pointed non-metallic object, then pull out the lithium battery. D Close the battery cover until it clicks in place.

(MONO)

Video heads cleaning
The heads get dirty in the following cases: � in an environment prone to extreme temperature or humidity � in a dusty environment � flaw, dirt or mold on video tapes � continuous usage for a long time Use a dry cleaning cassette � TCL-2 � when: � Rough, poor picture appears while a tape is played back. � The picture is unclear or no picture appears. � �USE CLEANING CASSETTE� appears on the screen (only with �O.S.D.� set to �ON� ( 15)).

Usable cassettes
� Compact VHS camcorder recordings can be played on this video recorder. Simply place the recorded cassette into a VHS Cassette Adapter and it can be used just like any full-sized VHS cassette. � This video recorder can record on regular VHS and Super VHS cassettes. While only VHS signals can be recorded on regular VHS cassettes*, both VHS and Super VHS signals can be recorded and played back using Super VHS cassettes.
* By using the S-VHS ET function, it is possible to record and play back with S-VHS picture quality on VHS cassettes with this recorder ( 16).

�2�