ION-AUDIO ICJ01
Quick Start

FRONT PANEL FEATURES
1. Replaceable Crossfader: This slide fader blends audio between channels 1 and 2. Note: This fader is user replaceable if it should ever wear out. Simply remove the face plate and then remove the screws holding it in position. Replace the fader with an authorized replacement from ION Audio Customer Service. Power LED: Illuminates when the mixer is on. Gain: This adjusts the channel�s input level. Turn it up as far as possible without distorting. Cue Select: Use this switch to

REAR PANEL FEATURES

2. 3. 4.

5.

determine what you hear through the headphones. When set to the left, you will hear Channel 1. When set to the right you will hear Channel 2. At the center, you will hear the Master output, which includes the microphone and crossfader. Input Selector: This toggles what input source is routed to the channel from the rear panel inputs. The left selects the Phono (turntable) or Line (CD Player) and the right selects the USB Audio Input. While using the iCJ01 with your computer, the switch should be right, selecting the USB audio inputs. Mic Level: This knob adjusts the volume of the microphone input. Master: This adjusts the main output volume. Cue Gain: This adjusts the volume level to your headphones. Headphone Jack: Plug in your headphones here. The volume should always be set at its lowest setting while connecting and disconnecting headphones to prevent damage to headphones and/or your hearing.

11. USB Input 1/Master Level Output: This USB jack sends the audio from your computer to Channel 1. This is also the simultaneous master output for recording. This output level is adjusted by the master gain control. 12. USB Input 2/Record Level Output: This USB jack sends the audio from your computer to Channel 2. This is also the simultaneous fixed recording output for recording. This output level is fixed. NOTE: Your mixer can simultaneously record through the USB Output while it is playing audio sources. For more information refer to the �Using your USB Mixer with a Computer� manual included. 13. Power Switch: Use this switch to turn on the mixer after all input devices are already connected to prevent damage to your equipment. Turn the mixer on before you turn on amplifiers and turn off amplifiers before you turn off the mixer. 14. AC In: This mixer is designed to work with the power supply assembly that comes with the unit. While the power is switched off, plug the power supply into the mixer first, then plug it into the outlet. 15. Master Output (RCA): This output is for connecting an external amplifier such as a PA system, powered monitors or a home stereo. The level of this output is controlled by the master knob. 16. Line Inputs: CD players, tape players, portable MP3 players or other linelevel devices should be connected to these inputs. 17. Phono Inputs: This input is used for connecting your turntables. Only turntables with phono level output should be attached (most turntables have phono outputs). 18. PHONO/LINE Switch: This switch is used to select between the Line inputs and Phono inputs on each channel. 19. GND: This screw connector should be used to secure the ground lead from a turntable. Note: It is recommended that the mixer be turned off before connecting and disconnecting any sources to the inputs of the mixer. Please see the separate manual for using the USB features of your mixer.

6. 7. 8. 9.

10. Microphone Input: Microphones with a ¼� connector can be connected to this jack.

3

4