|
|
|
Who's Online
There currently are 5718 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
;
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
11. Removethe base grille by grasping at both ends and pulling it straight out. 12. Remove the hinge cover by squeezing both sides together. 13. Use a 5/16" socket and ratchet to remove the two screws from the bottomhinge. Save the spacer. "14. Pull the metal hinge pin from the sideof the lower hingeand place it, includingthe spacer washer, into the top hole. 15. Pry out the two screw hole plug buttonson the bottomleft side of the top door and lower door. Removethe door stops (metal plate) on the bottomof each door and install them on oppositesides. Press in the plug buttons in the holes on the right side of bothdoors. 16. Set the lowerdoor on the bottom hinge,making sure the hinge pin enters the bushing in the door bottom. 17. While holding the door in a closed position,take the center hingepin that was removed in step 3 andinsert it through the left hole of the center hinge andinto the bottom door bushing. Make sure the long pin goes into the bottomdoor and the short pin goes into the top door. 18. Set the upper door on the center hinge, making sure the hinge pin enters the door bushing. When you close the door, the gasket should hold it in place. 19. Makingsure to use the same numberof spacers that were originally used beneaththe upperhinge, install the hinge mounting screws. Beforetightening these screws, make sure the top of the door is level with the cabinet top, and the space between the door is equidistantacrossthe entirefront. Avoidover-tighteningthese screws. Tighten both until they are just snug, then turn them in another one-halfturn. 20. Examinethedoor gasketall around each door, makingsure no gaps are visible between the gasket and cabinet. If a gap shows, try stretching the gasketaway from the door so the magnet will contact the cabinet surface. 21. To replacethe basegrille, line up its springclips with the square openingsin the cabinet and tap each end in until the gnlle locks in place. Replace hinge cover. 22. Replaceall food and return the fresh food control to its usual operating position.
|
|
|
> |
|
