JVC KD-DV5000
Owner's Manual

ENGLISH

2

Tune in to a station (in this example, of 92.5 MHz).
To tune in to stations of higher frequencies

Tuning in to a preset station
You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see �Storing stations in memory� on pages 13 and 14.

To tune in to stations of lower frequencies

Selecting a preset station directly

1

Select the band (FM1 � 3, AM).
SRC

1 Press SRC (source) repeatedly to select the tuner. 2 Press and hold SRC. Each time you press and hold the button, the band changes.

3

Press and hold the number button (in this example, 1) for more than 2 seconds.
1

FM1

FM2

FM3

AM

2

Select the number (1 � 6) for the preset station you want.
1 2 3 4 5 6

The display pattern automatically changes like the above pattern (see page 15). The preset number flashes for about 5 seconds, then the previous display pattern resumes.

Note: You can also use the 5 (up) or � (down) button on the unit to select the next or previous preset stations. Each time you press the 5 (up) or � (down) button, the next or previous preset station is tuned in.

4

Repeat the above procedure to store other stations into other preset numbers.

When using the remote controller 1 Press FM or AM. FM
� When selecting the FM bands, press FM repeatedly until the band you want is selected.

DAB

Notes:
� A previously preset station is erased when a new station is stored in the same preset number. � Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.

AM

2 Press the number buttons (1 to 6) while
holding SHIFT (S).
SHIFT
TOP MENU
1
DISC +

MENU
2 3

S

ENTER
4 5 6

Note: You can also use the PRESET (FOLDER) 5 / � buttons for selecting a preset station.

14