|
|
|
Who's Online
There currently are 5845 guests and
15 members online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Hard to find manual was ready the next day. Scans were very legible (including schematics). All the essential parts of the service manual were present (adjustment procedure, schematics, and parts list). It would have been nice if the rest of the manual was included (disassembly procedure, theory of operation, etc.).
 ;
The Service Manual for the Kenwood KR-V55R provided by owner-manuals.com was as described/advertised. The contents provided the necessary information to effect a diagnosis of the unit. The schematics above all else was instrumental in tracing the the signal flow from component to component.
;
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
;
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
;
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
KD-LH1000R Removing the trigger arm (See Fig.18 and 19)
Prior to performing the following procedure, remove the top cover, the connector board and the clamper unit. 1. Turn the trigger arm in the direction of the arrow to release the joint k and pull out upward.
Joint k
Trigger arm
CAUTION: When reassembling, insert the part l and m of the trigger arm into the part n and o at the slot of the chassis rivet assembly respectively and join the joint k at a time.
Chassis rivet assembly
Fig.18
Part n Trigger arm Part l Part m Part o
Chassis rivet assembly
Fig.19
Removing the top plate assembly (See Fig.20)
Prior to performing the following procedure, remove the top cover, the connector board, the chassis unit, and the clamper assembly. 1. Remove the screw H. 2. Move the top plate assembly in the direction of the arrow to release the two joints p.
Top plate assembly
H
Joints p
q
3. Unsolder the wire marked q if necessary.
Fig.20
1-12
|
|
|
> |
|
