|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fast service, document is OK. Thanks! Searched for it long time.
 ;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
;
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
How to use gas burners
Place the pot over the pot support fitted above the hob. For small pots with a diameter of less then 7� (175 mm), the trivet must be used in combination with the 2-zone wok burner. Make sure the trivet is securely fixed to the pot support. Push the appropriate control knob, turn it counter-clockwise to the setting �HI�. If the burner fails to ignite, check that: � the burner cap is positioned correctly; � the burner is clean and dry. To switch off the gas supply to the burner, turn the control knob, in a clockwise direction, to the �OFF� position. If the flames are not uniform, check to ensure When cooking or boiling in large pots or pans, ensure that there is a minimum distance of 2� (50 mm) between the pot and a heat-sensitive worktop. After combustion, the hot gases flow outwards under the base of the pot and may consequently burn the edge of the worktop if it is too close. Make sure there is a minimum distance of 5/8� (15 mm) between the pot or pan and the control panel. Never place a pot on the control panel. If the flames are irregular and yellow, check to ensure that a pressure regulator has been installed. Do not use the appliance and inform the installer. that the burner cap is properly positioned on the ring.
Right Wrong Right Wrong
Check to ensure that the burner is burning correctly. The flames should be blue and uniform.
6
|
|
|
> |
|
|
Parse Time: 0.254 - Number of Queries: 128 - Query Time: 0.051
