|
|
|
Who's Online
There currently are 5779 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
(-
KV-133;fW&�,
3-2.
l l l
CONVERGENCE
:
4.
Preparation
When the V.STAT magnet is moved in the direction of arrow @ and @ , Red, Green and Blue dots move as shown below.
Before starting, perform FOCUS, H. SIZE and V. SIZE adjustments. Set BRIGHTNESS control to fully counterclock wise. Feed in the dot pattern.
(1) Horizontal and Vertical Static Convergence
Center dot
El
G DRIVE
B
G
I
R
B BKG G BKG R BKG
SUB BRT
1.
Adjust H. STAT VR to coincide red, green and blue dots on the center of screen. (Horizontal movement) Adjust V. STAT magnet to coincide red, green and blue dots on the center of screen. (Vertical movement) If the red, green and blue dots do not coincide on the center of screen with H. STAT VR, perform horizontal convergence adjustment using H. STAT VR and V. STAT magnet as shown below. (In this case, H. STAT VR and V. STAT magnet effect each other.) Tilt the V.STAT magnet and adjust static convergence to open or close the V. STAT magnet.
If blue dot dose not coincide with red and green dots, perform following steps. Move BMC magnet (a) to correct insufficient H. static convergence. Rotate BMC magnet (b) to correct insufficient V. static convergence. In either case, repeat Beam Landing Adjtstment.
2.
3.
MC Magnet
0
- 13 -
|
|
|
> |
|
