|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
 ;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
KV-25X5
(4)
�
Screen corner convergence.
If you are unable to adjust the corner convergence properly, this can be corrected by the use of permalloy assemblies.
3-3. Screen [G2], White balance
G2 Setting
1. 2. 3. 4. Input a dot signal from the pattern generator. Set the Picture, Brightness and Colour to minimum. Apply 170Vdc from an external power supply to the R, G and B cathodes of the CRT. Whilst watching the picture, adjust the G2 control [RV701 SCREEN] located on the C Board to the point just before the flyback return lines disappear.
a a-d: screen-corner convergence defect c
b
d
White balance adjustment
1. 2. 3. 4. 5. Input a �PAL� all-white signal from the pattern generator. Enter into the Service Mode. Enter into the �Picture� service menu. Select the �Green drive� and adjust so that the White Balance becomes optimum. Select the �Blue drive� and adjust so that the White Balance becomes optimum. Set the Picture to MIN. Set the �R-cut-off� to 07. Adjust the �G-cut-off�, and the �B-cut-off� so that the White Balance becomes optimum. Press the button to return to TV operation.
Fit the permalloy assembly to the rear of the CRT to correct the area at fault.
a
6. 7. 8. 10.
b
PICTURE
R - Drive G - Drive Permalloy
c d
Adj Adj Adj Adj Adj Adj 02 01 01 Adj Adj Adj
B - Drive R - cut - off G - cut - off B - cut - off ID - start ID - stop ID - level Bellfo Sub Colour Sub Brightness
3-4. FOCUS
1. 2. 3.
FOCUS
Input a Phillips colour pattern Set the picture settings to normal. Adjust the focus control located on the Flyback transformer to bring the centre of the screen into focus. Note :Bring only the centre area of the screen into focus, switch to an all-white pattern and confirm that the magenta ring is hardly noticed. To obtain optimum focus balance the focus setting between optimum screen centre focus and a reduced magenta ring level.
19
|
|
|
> |
|
