|
|
|
Who's Online
There currently are 5828 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
KV-ES29M31/ES29M61
The operating instructions mentioned here are partial abstracts from the Operating Instruction Manual. The page numbers of the Operating Instruction Manual remain as in the manual.
SECTION 1 GENERAL
RM-916
WARNING
� Dangerously high voltages are present inside the TV. � Operate the TV only between 110 � 240 V AC.
Using Your New TV
Getting Started
Step 1
Connect the antenna
If you wish to connect a VCR, see the �Connecting a VCR� diagram below.
For your own safety, do not touch any part of the TV, the power cord and the antenna cable during lightning storms.
Rear of TV
Install the TV in a stable position. Do not allow children to climb onto it.
or
Antenna cable (not supplied) IEC connector (not supplied)
� 8 �
To prevent fire or shock hazard, do not expose the TV to rain or moisture. Do not install the TV in a confined space, such as a bookcase or built-in cabinet. Do not block the ventilation openings of the TV. Pull the power cord out by the plug. Do not pull the power cord itself. Disconnect the TV if you are not going to use it for several days. Do not open the cabinet and the rear cover of the TV. Refer servicing to qualified personnel.
Do not operate the TV if any liquid or solid object falls into it. Have it checked immediately by qualified personnel only.
Antenna cable (not supplied)
: Signal flow
CAUTION Do not connect the power cord until all other connections are complete; otherwise, a minimal current leakage through the antenna and/or other terminals to the ground could occur.
Connecting a VCR
To play a video tape, press t (see page 11).
Clean the TV with a dry and soft cloth. Do not use benzine, thinner, or any other chemicals to clean the TV. Do not scratch the picture tube.
To � (antenna) Antenna cable (not supplied) Rear of TV
Do not plug in too many appliances to the same power socket. Do not damage the power cord.
To antenna output VCR
To (S video input) S video cable (not supplied)
Y CB CR L L
DIGITAL IN (DOLBY DIGITAL/PCM)
AUDIO VIDEO R VIDEO IN VIDEO OUT L
(MONO)
To S video output
R 1 2 3
R
Do not install the TV in hot, humid or excessively dusty places.
To video and audio outputs Audio/Video cable (not supplied)
To t 1, 2 or 3 (video input) (yellow) -L (MONO) (white) -R (red) : Signal flow
2
4
Using Your New TV
|
|
|
> |
|
