Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
Text excerpt from page 25 (click to view)
2-10. PICTURE TUBE � REMOVAL OF ANODE-CAP
NOTE : After removing anode, short circuit anode of the picture tube and CRT. 4 C5 board
3 F board anode cap to metal chassis, CRT shield or carbon paint on the
� REMOVING PROCEDURES 7 Neck assy
2 A board
a
5 Deflection yoke a
6 Four screws
(Tapping screws) 1 Turn up one side of rubber cap in direction indicated by the arrow a.
b b
1 Anode cap
2 Using a thumb pull up rubber cap firmly in direction indicated by the arrow b.
c
� 25 �
Cushion 3 When one side of rubber cap is separated from anode button, the anode-cap
can be removed by turning rubber cap and pulling it up in direction of the arrow c.
Anode button
� HOW TO HANDLE AN ANODE-CAP
1 Do not damage the surface of anode-caps with sharp shaped objects. 2 Do press rubber too hard so as not to damage the inside of anode-cap. A metal fitting called shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.
